Posted on 2 Comments

How to hang a Roman Blind

Here’s some simple instructions on how to fit the cords and hang a roman blind using the traditional batten and cord system – if you are using a cassette it will be different. You should already have a batten fixed above your window, with the Velcro and eyelets attached; if you need some help on how to do this see our guide on how to fix a batten for a Roman blind. This guide will also help you to replace worn parts in an existing blind.

rating beginner

Time needed: 30 minutes.

  1. Threading the cords


    Lay the roman blind face down on a clean table or surface. Thread the cords though the eyelets from the top of the blind to the bottom and secure them by threading through the safety device. You now need to decide on which side you would like the pull cord, as this will affect the direction the cords are threaded in the next step.

  2. Fixing the blind to the batten


    Secure the blind onto the batten by pressing the Velcro strips together. Threading the cords is easiest if you are able to stand in front of the window but behind your blind, if you can reach the eyelets on the batten from here.

  3. Attach the cords to the batten

    Thread the cords through the corresponding eyelets on the batten. Either work left to right (cord will hang on the left) or right to left (cord will hang on the right). Thread all of the loose ends through your wooden acorn to keep them together and tie a loose knot to stop them slipping back through. Do not cut off the excess at this point.

  4. Adjusting the cord length

    In order to ensure you have the correct length of cord, pull your roman blind up and down a few times to make sure it runs level. To determine where to cut, you should let the blind hang all the way down so that the acorn will be at its highest point. You should have a short distance between the last eyelet on the batten and the acorn. Tie a small knot here to keep the cords together and then cut off the excess, the knot should be hidden inside the acorn when it is pulled down over it.

  5. Adjustment

    If you find that your blind has moved slightly after your adjustments and is no longer level, you can fix this easily by pulling one or more of the cords through the safety devices on the bottom of the blind, adjusting where it hangs longer or shorter.

  6. Fixing the cleat

    The cleat should be secured next to the blind cord at least 1.5m above the floor, this, along with the blind safety devices is to reduce the risk of strangulation in small children. The cleat requires two screws to be screwed through it and into the wall (or other fixing point) in order to secure it.
    Safety note: When the Roman Blind is pulled up the cord must be fully wrapped around the cleat, so that there is no excess hanging down for small children to be able to reach.

  7. Your blind is ready to use!

    Remember, you can also use this guide to replace the parts on a roman blind when they become broken or worn, keeping your blinds in perfect condition for years to come. At Livingstones we believe we should all able to repair our things, so we sell roman blind cord by the metre.

Print Friendly, PDF & Email

2 thoughts on “How to hang a Roman Blind

  1. Do you make the roman blinds or eve the roller blindS? Id like to know how much it would cost with the flying seagulls. the blind would be 26 1/2 W 30IN LONG

    1. Hi Sandra, yes we can make roman blinds and we can outsource roller blinds in our fabric. For a Roman Blind you would need a metre of seagulls fabric at £12.75 plus linings and kit at £35 so materials would come to £47.75. Making would be £68 labour so the total cost will be £115.75 for a finished Roman Blind. Any postage would be extra.
      Many thanks for your enquiry

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.